Home » Blog » How To Setup Dlink Dir 819 Router?

How To Setup Dlink Dir 819 Router?

dlink dir 819 router setup

D-Link DIR 819 is one of the best wifi routers for your internet requirements.

If you buy a new Dlink router and are looking to setup a Dlink router 819 your router, follow the step-by-step guide below.

Steps To Setup Dlink DIR 819 Router

  • Plug the broadband ethernet cable in the laptop or computer.
  • Check the internet speed by visiting fast.com.
  • Remove the broadband cable from the computer and router both.
  • Plug in the old charger type pin into the adaptor socket.
  • Plug the broadband ethernet cable in the yellow jack of your router.
  • Plug the yellow cable in any of the ethernet ports of your router.
  • Plug the other end of the yellow cable in your router.
  • Go to your laptop network section and click on the ethernet icon.
  • Click on the change adaptor option.
  • Right click on the ethernet option, choose properties.
  • Go to ethernet protocol version 4 (TCP/IPv4)
  • Click properties and note down all IP addresses.
  • Click on automatic configure Ip address.
  • Now enter dlinkrouter.local in the browser window.
  • Click ok on the window.
  • Select your static IP.
  • Click on next.
  • Fill all the IP address properties.
  • Click Next.
  • Set the username and password for your 2.4ghz and 5ghz.
  • Click on next.
  • Enter admin password.
  • Now select the timezone according to your timezone.
  • Click Next.
  • After 10-15 sec your all Ip addresses are activated.
  • The internet service provider page will be open.
  • Login to your broadband page.
  • Connect wifi with your phone.
  • Check internet speed on fast.com
  • Connect the 5ghz wifi  and check speed again.

Now your Dlink Dir 819 setup is successfully done, if you are looking for another way to setup your router, you can setup your router through Ap mode.

Steps To Update Firmware of your Dlink Dir 819 

  • Enter dlinkrouter.local in the browser window.
  • Login with your credentials.
  • Click on tools and select firmware.
  • Click on automatic firmware or you can download firmware.
  • Upload the firmware in the manual option below.

Leave a Reply

Your email address will not be published. Required fields are marked *